Page 1 of 1
Looking for army numbers..
Posted: Mon May 12, 2008 11:08 pm
by Radditz68
In some screen shots I have seen in the AAR forum, I have seen a mod I would assume that shows the total troops/cannons/horses etc in the battle result window. What mod might that be that shows it? Thanks in advance, I have been playing this game for a month now mostly as the CSA. Basicly because, I would think it would be too easy to play as the union. Eh, in the long run anyway.
Posted: Mon May 12, 2008 11:10 pm
by Rafiki
Hi Radditz, and welcome to the forums
That "mod" is the latest patch. I'm not sure when the numbers were introduced, but I recommend upgrading to the latest patch in any case
Posted: Tue May 13, 2008 7:36 am
by Primasprit
That "mod" is the latest patch. I'm not sure when the numbers were introduced,[...]
1.09a
Posted: Tue May 13, 2008 8:35 am
by Rafiki
Primasprit wrote:1.09a
Sounds about right
Posted: Tue May 13, 2008 10:01 pm
by Radditz68
Odd, I have the latest patch installed, yet I still do not see the total number of men involved under the generals like I have seen in screen shots. Maybe I have to reinstall and try again.
Posted: Tue May 13, 2008 10:12 pm
by arsan
You have to press the control key to see the numbers on the unit panel.
But on the battle report you should see them always... don't you??
Regards!
Posted: Tue May 13, 2008 10:36 pm
by Radditz68
After looking closer, my game still says its running 1.03. I have reapplied 1.10, still says 1.03. I am at total lose.
Posted: Tue May 13, 2008 11:17 pm
by arsan
Hmm.. it looks like you are not applying the patch to the correct folder...
Did you change the default installation folder for the game?
If yes, you should point the installer to the correct new one.
Recheck this. If the game load screen does not say 1.10, then the patch is not being applied as it should...
Posted: Wed May 14, 2008 2:57 am
by Radditz68
Wow.. I can't beleive I did that.. I have it installed in D:, and kept installing the patch to C:
