runyan99 wrote:The attack/defense numbers give a percentage bonus to the strength of the unit, at 5% per point.
How the strength numbers factor into combat, I really don't know, because I don't know how the game calculates battles.
As far as who the bonus applies to, I assume divison leaders lend their bonus, and then corps commanders.
So, I assume a divsion with a strength of 200 would get a 10% bonus from a division leader with a rating of 2, and then another 10% bonus from a corps commander with the same rating. So 200*1.1*1.1=242
Also, remember that Army leaders pass bonuses along to the corps commanders' stats, but don't add another 'layer' of bonuses to the units. Not 200*1.1*1.1*1.1=266 for example.
That's what I think, but I could be wrong.
Well, I think that after a few tests I have discovered a few generalizations, although I am not entirely sure of the reasoning behind it.
I gathered 3 leaders. A 3-0-0, 3-1-1 and 3-2-2. I put them in various levels of command, and found that both the stack commander's combat abilities, and the divisional commander's combat abilities affect the strength.
The only factor changing is the stack commander (the divisional commander remains at 3-1-1)
With the 3-0-0 in command of the stack (corps for simplicity sake, but all are 1 star) I found that a unit 'lost' strength. For example, a 325 division went down to 300 (stack's total power, the division showed 325) when the 3-0-0 was in charge of the stack. When a 3-1-1 was in charge of the stack, the division and stack power remained the same (at 325 for both). When the 3-2-2 was in charge of the stack, the power increased to 350 (or something like that).
Also, the division commander directly affected the strength, although they appear to affect it somewhat less than the corps commander.
So, while Divison and Stack commanders are important, having a good Stack commander is more important than good division commanders. However, I am not sure on the aspects of the units that the attack and defence values affect, and to what extent (increasing ability of particular element statistics will increase the combat value, but I am not sure what it changes, and to what extent).
So, I have noticed that a 3-1-1 stack commander applies no bonus to the stack. A 3-0-0 stack commander places a penalty on the stack. A 3-2-2 (or more) places a bonus on the stack.
However, I noticed that a 3-0-0 divisional commander increases the power of the stack (albiet not by much). Here's a test done on a 60 point brigade attached to a 3-0-0, 3-1-1 and 3-2-2.
60 point brigade attached to the 3-0-0 resulted in a brigade strength of 64
60 point brigade attached to the 3-1-1 resulted in a brigade strength of 66
60 point brigade attached to the 3-2-2 resulted in a brigade strength of 68
So, it seems like a 3-0-0 is actually more useful as a divisional/brigade commander, as applied to the unit they still give a bonus (while applied to a stack they initiate penalties). Also, the increase from a 3-0-0 to a 3-1-1 in power is neglegable (adding a 3-0-0 gives a 60 point brigade +4, while adding a 3-1-1 gives a 60 point brigade a +6). Based on these rates (which I believe are constantly going up by +2 for a 60 point unit), a 3-6-6 would give a 60 point brigade a +16. Indeed, the larger the unit, the greater the impact, but, a 3-0-0 is still very useful given that most units are 3-1-1 (currently).
I have no clue as to what rate the increase is based on attack or defense (for example, if a 3-0-1 is better/worse/same as a 3-1-0), or how much strategy may take a part in divisional strength (if any).
I would appreciate it if someone from AGEOD could lay out the way Armies, Corps and Divisions use the three different stats (Strategic, Offensive, Defensive).
Thanks!