Page 1 of 1
Leader bar covering jump map
Posted: Sun May 24, 2015 1:19 pm
by AndrewKurtz
Small item, but I think the leader bar needs to be moved up. There is room up and it is covering overlays and the jump map.
[ATTACH]33618[/ATTACH]
Posted: Sun May 24, 2015 2:52 pm
by Captain_Orso
Dang AK, what are you playing on, an iWatch?
Actually, with 4 armies opened, the other bars start right below the 4th army. Pocus might be able to push the whole thing up just a bit, but not much
Posted: Tue May 26, 2015 9:14 am
by Pocus
What is your screen resolution, in 768 pixels high, it should not give you troubles. If it does, I can check that.
Posted: Tue May 26, 2015 12:03 pm
by AndrewKurtz
ScreenWidth = 1600
ScreenHeight = 900
ScreenDepth = 16
ScreenFrequency = 60
Cursor = Software
FullScreen = 0
Windowed = 1
Borderless = 0
Posted: Tue May 26, 2015 4:36 pm
by Captain_Orso
Can you put up a screen shot with the full hight of the left side of the map showing all of the army wrappers?
Posted: Wed May 27, 2015 12:12 pm
by AndrewKurtz
[ATTACH]33640[/ATTACH]
Posted: Wed May 27, 2015 1:43 pm
by Captain_Orso
If you think this is bad, you should look at 1024x768
This is actually what I was looking for:
I think Pocus could shift everything up a little bit, but not much and you'd still have the Army Bars covering the Filter Selection Icon.
I think the only viable solution would be to reduce the number of opened Army Wrappers to 3 for resolutions under 1000 pixel in hight and shift the unopened wrappers upward, or maybe change it to that for all resolutions. *psst* I don't really ever use the Army Wrappers
